Using The Expression Pedals; Using The Control Pedal And Expression Pedal Switch - Roland FC-300 Owner's Manual

Control Change Mode

Using the Expression Pedals

In keeping with the movement of the expression pedal, Control Change messages
with the controller numbers set for each pedal are transmitted consecutively.
Each pedal is set at the factory as shown below.
Expression Pedal
EXP PEDAL 1
EXP PEDAL 2

Using the Control Pedal and Expression Pedal Switch

Control Change messages with the controller numbers set for each pedal are
transmitted.
Each pedal is set at the factory as shown below.
Pedal
CTL PEDAL 1
CTL PEDAL 2
EXP PEDAL SW 1
EXP PEDAL SW 2
22
CC#
7
1
CC# Range
80 0–127
81 0–127
82 0–127
83 0–127
Range
0–127
0–127
Mode
LATCH
LATCH
LATCH
LATCH
For details about the all
parameters and changes the
setting, refer to "Change the
Pedal Settings" (p. 24).
The Control pedal is a
momentary type pedal that
sends an ON message when
depressed and an OFF
message when released. You
can change this to latch type
operation, which sends an ON
or OFF message each time you
depress it – see "Mode" (p. 25).
You can use the control pedal
and expression pedal switch to
switch the AMP CONTROL
jacks – see "Change the Pedal
Settings" (p. 24).