Checking The Installed Wave Expansion Board - Roland JUNO-G Owner's Manual

4.
Use the Installation Tool supplied with the Wave Expansion
Board to turn the holders in the LOCK direction, so the
board will be fastened in place.
fig.Exp4.e
Installation tool
5.
Use the screws that you removed in step
cover back in place.
Checking the Installed Wave
Expansion Board
After installation of the Wave Expansion Board has been completed,
check to confirm that the installed board is being recognized
correctly.
1.
Turn on the power, as described in p. 15.
2.
Press EDIT [MENU] to open the Top Menu window.
3.
Press [ ] [ ] to select "2. System," and then press
[ENTER].
4.
Press [F6 (INFORMATION)].
The SYSTEM INFO screen appears.
5.
Press [F2 (SRX)].
Verify that the name of the installed Wave Expansion Board is
displayed.
fig.SRXInfo
* If the name of the board does not appear, it is possible that the board is
not being recognized correctly. Turn off the power as described in
Turning Off the Power (p. 15), and re-install the Wave Expansion
Board correctly.
6.
Press [EXIT] to exit the SYSTEM INFO screen.
LOCK
2
to fasten the
Installing the Wave Expansion Board
175