Installing A Wave Expansion Board - Roland XV-2020 Owner's Manual

Installing a Wave Expansion Board

Two Wave Expansion Boards (SRX series; sold separately) can be
installed in the XV-2020.
Waveform data, patches and rhythm sets are stored on the Wave
Expansion Board, so you can increase the number of available
sounds by installing the board in the XV-2020.
Installing a Wave Expansion Board increases the patches and drum
sets for Parts, but the number of Parts doesn't change.
The Wave Expansion Board can be installed by removing the top
cover.
Cautions When Installing an
Wave Expansion Board
• To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the
following whenever you handle the board.
Before you touch the board, always first grasp a metal object
(such as a water pipe), so you are sure that any static
electricity you might have been carrying has been
discharged.
When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
Save the bag in which the board was originally shipped, and
put the board back into it whenever you need to store or
transport it.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Never use excessive force when installing a circuit board. If it
doesn't fit properly on the first attempt, remove the board and
try again.
• When circuit board installation is complete, double-check your
work.
• Install only the specified board, and remove only the specified
screws.
• Be careful not to cut your hands on the opening for installing
the board.
106
Expansion Board
1.
Before installing the Wave Expansion Board, switch off the
power to the XV-2020 and any connected equipment.
2.
Detach the cover on the upper portion of the XV-2020.
Loosen the screw on the upper portion of the cover.
fig.1-03a.e
Driver
3.
Position the board holders so they are oriented.
fig.Install2.e
Holder
4.
Insert the connector for the Wave Expansion Board into the
connector on the unit, and at the same time, fit the board
holders into the holes.
fig.Install3.e
Holder
5.
Use the tool supplied with the Wave Expansion Board to
rotate the board holders to LOCK, securing the Wave
Expansion Board in place.
fig.Install4
LOCK
6.
Use the (specified) screws you removed in step 2 to
reattach the cover.
This completes the installation of the Wave Expansion Board.
Next, make sure the board is installed correctly.
Connector