Checking The Propeller Shaft Housing; Checking The Propeller Shaft; Assembling The Propeller Shaft Assembly - Yamaha E60HWD Service Manual

2. Remove the ball bearing.
cC
Do not reuse the bearing, always replace it
with a new one.
Stopper guide plate 5:
90890-06501
Stopper guide stand 6:
90890-06538
Bearing puller assembly 7:
90890-06535
3. Remove the oil seals and needle bearing.
Needle bearing attachment 8:
90890-06612
Driver rod L3 9: 90890-06652
Checking the propeller shaft hous-
ing
1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it for cracks. Replace if necessary.
2. Check the teeth and dogs of the reverse
gear for cracks or wear. Replace the gear
if necessary.
69D5G11
Propeller shaft housing
3. Check the bearings for pitting or rum-
bling. Replace if necessary.

Checking the propeller shaft

1. Check the propeller shaft for bends or
wear. Replace if necessary.
2. Measure the propeller shaft runout.
Runout limit: 0.02 mm (0.0008 in)
3. Check the dog clutch and shift slider for
cracks or wear. Replace if necessary.
Assembling the propeller shaft
assembly
1. Install the dog clutch 1 and the slider 2
as shown.
b
2
a
NOTE:
9 Install the dog clutch 1 with the "F" mark a
facing toward the shift plunger.
9 Install the slider 2 with the "F" mark b fac-
ing toward the shift rod.
6F660130
1
69D60060
6-14
1
2
3
4
5
6
7
8
9