Special Setup For The Copy; Resolution Setup; Zoom Setup; Analysis Origin Setup - Ricoh LASER FACSIMILE Operating Instructions Manual

Laser Facsimile

Special setup for the copy

Setups done through this menu become the device
default setups after you confirm.
When the quality of the printing is not
satisfying, you can proceed to a
Important
calibration with MENU 80.

Resolution setup

The RESOLUTION parameter allows you to setup the
photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Choose the resolution with the buttons
according to the following table:
Parameter
Low resolution.
DRAFT
Standard resolution for documents
AUTO
containing text and graphics.
Optimal resolution for documents
QUALITY
TEXT containing text.
Optimal resolution for documents
PHOTO
containing photographies.
2 Confirm your choice by pressing the OK button.
You can also setup the resolution
Note
by pressing the

Zoom setup

The ZOOM parameter allows you to reduce or enlarge an
area of a document by choosing the origin and the zoom
level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING
1 Enter the desired
Alpanumerical keyboard
predefined values with the buttons
2 Confirm your choice by pressing the OK button.

Analysis origin setup

If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 210 and
Y < 280), you move the analysed area as shown on the
diagram below.
or
Signification
button.
zoom level with the
or choose among
and .
- 20 -
x
y
844 - ADVANCED FCT/COPY/ORIGIN
1 Select the X and Y coordinates with the buttons
or .
2 Setup the desired coordinates with the digital
keyboard or the buttons
choice by pressing on the OK button.

Contrast setup

The CONTRAST parameter allows to choose the
photocopy contrast.
845 - ADVANCED FCT/COPY/CONTRAST
1 Setup the desired level of contrast with the buttons
and , confirm by pressing the OK button.
2 You can also directly setup the desired contrast
with the button, press several times on this
button until the desired setup without using the
Menu 845.
3 Quit this menu by pressing the

Luminosity setup

The LUMINOSITY parameter allows to lighten or darken
your original document.
846 - ADVANCED FCT/COPY/LUMINOSITY
1 Setup the desired brightness with the buttons
and .
2 Confirm your choice by pressing the OK button.
3 Quit this menu by pressing the

Paper type setup

851 - ADVANCED FCT/SCAN. & PRINT/PAPER
1 Select the paper NORMAL or THICK that you use
with the buttons
2 Confirm your setup by pressing the OK button.
3 Quit this menu by pressing the

Paper tray selection

The Automatic selection can have two meanings
depending on the paper format defined on the paper
trays. The following table describes the different cases.
Analysed area
and , confirm your
button.
button.
TYPE
and .
button.