Table of Contents
Advertisement
B B B B
Slide the side guides outward
(A A A A ), and then load paper until it
stops with the print side up (B B B B ).
C C C C
Adjust the side guides to the pa-
per width.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Shuffle the paper before loading
the stack onto the tray so multi-
ple sheets are not fed in at one
time.
D D D D
Set the paper size using the con-
trol panel as follows:
A Press { { { { Menu} } } } .
ZDJH204J
"Menu" appears on the panel
display
B Press { { { { U U U U } } } } or { { { { T T T T } } } } to "Paper In-
put" menu, and then press { { { { En-
ter} } } } .
The following message appears
on the panel display.
Menu:
Paper Input
C Confirm that "Bypass Size" is
ZDJH205J
displayed, and then press { { { { En-
ter} } } } .
The following message appears
on the panel display.
Paper Input:
Bypass Size
D Press { { { { U U U U } } } } or { { { { T T T T } } } } to display the
size and direction of the paper
in the bypass tray.
Bypass Size
*11 x 17
After about two seconds, the
display is returned to the menu.
Loading Paper
3
ZDJS001J
65
Advertisement
Table of Contents
