Ricoh PRIPORT VT2130 Operating Instructions Manual page 8

14.
Master Cut Button
Press this button to cut the master paper lead-
15.
Pressure Release Lever
16. Drum Rotation Button
17. Drum Unit
18. Ink Holder
19. Main Switch
20. Small Size Paper
Delivery End Plate
(for smaller than
81/2"x 1l")
21. Paper Delivery End
Plate
(for larger than
81/2" x 1
l")
22. Paper Delivery Side
Plate
23. Master Eject Container
Cover
24. Printing Density Select
Switch
25. Master Eject Unit Open
Button
ing edge after installing a new master roll.
Use to install the master roll, or to clean the
thermal head.
Press to replace the drum or to remove misfed
paper.
The master paper is wrapped around this unit.
Set the ink cartridge in this holder.
Use to turn the power on or off.
Use to align the leading edge of small-sized
(less than 81/2" x 11") prints.
Use to align the leading edge of prints larger
than 81/2" x 1l".
Use to align the prints on the paper delivery
table.
Open when removing the master eject box.
Use to select the printing density according to
the type and quality of the original.
Press to remove misfed paper or a misfed
master.
5