Ricoh PRIPORT VT2130 Operating Instructions Manual page 34

6. Press the Memory key again. The
Memory returns to Memory 1.
.
You only
need
to press the Memory key
again if you have stored the print quantity
for less than 10 sets. The Memory auto-
matically returns
10th set is stored
7.
Set the
original
original table.
to Memory 1 after the
in Memory.
face down on the
I
I
8.Turn on the power switch of the op-
tional tape dispenser.
9. Press the Master Making key.
Check the image position of the trial
prints. (See page 19 to 20.)
10. Press the Print Start key.
After the last page of each printing set is
fed out to the delivery table, the tape dis-
penser drops a strip of paper onto the top
of the paper stack. This marks the end of
each printing set.
31