Troubleshooting; Indicators - Ricoh PRIPORT VT2130 Operating Instructions Manual

I
TROUBLESHOOTING
I
1. Indicators
[f a malfunction or a misfeed occurs within the machine, the following indicators will light.
-
Check the misfeed or malfunction location.
If a service code
representative.
Open the top unit cover, remove original and reset. (See page 43.)
Remove the jammed paper and press the Reset key. (See page 44.)
Remove the jammed master and
pressthe Resetkey. (See page 45.)
Open the master eject unit and remove any jammed paper, then press
the Reset key. If the paper is stuck to the drum, pull out the drum unit
until the drum unit hits the drum stopper,
and remove the jammed
paper
from the drum. (See page 46.)
1. If the paper is stuck to the drum, pull out the drum unit until the drum
unit hits the drum stopper, and remove the jammed paper from the
drum.
2. If the jam is in the paper feed section, the jammed paper may be
cleared at either the paper entrance or the paper exit side.
(See page 47.)
Open the master eject unit and remove the jammed master. Press Reset
key. If the jammed master is stuck to the drum, pull out the drum unit
and remove the misfed master. (See page 48.)
Open the master eject unit and remove the jammed paper. Press Reset
key. (See page 48.)
Check that the original is correctly placed and that the counter is set for
the required number of copies. (See page 49.)
Load paper. (See page 49.)
Load new master roll. (See page 49.)
Load new ink cartridge. (See page 50.)
1. Remove the used masters inside the master eject box.
2. Make sure the master eject box is replaced correctly. (See page 50.)
Check the setting of the original table, the front cover, the master eject
unit, the drum, the paper feed table, and the top unit. (Seepage 51.)
Color drum is installed.(See page 51.)
Set the key counter. (See page 51.)
(EO1– E08) is displayed
in the counter, please contact your service
42