Re-Registering - Mira Vision Dual Installation Manual

The wireless controller has previously been registered to the digital mixer valve
at the factory. If communication problems are encountered, a re-registering of the
wireless controller may be required.
A re-registering of the wireless controller must also be performed should the control
PCB in the digital mixer valve be replaced.
To re-register the wireless controller to the digital mixer valve carry out the following
sequence.
Isolate power to the digital mixer
valve.
Press "+" and "
simultaneously until "End" is
displayed on the screen.
Restore power to the digital mixer
valve.
Briefly press the "+" and "
buttons, "SET" will be displayed on
the screen. Note! if display reads
"Err" press "
process.

RE-REGISTERING

1
" buttons
1
"
1
" and repeat the
40