Mira Vision Dual Installation Manual page 33

Place the backplate over the
outlet pipe with the arrow pointing
vertically up and tighten the two
backplate screws. Make sure that
the foam seal abuts the finished wall
surface.
Fit the olive and the backplate nut
over the outlet pipe, do not tighten
the nut fully at this point.
Check that the 'O' seal is fitted to
the outside of the backplate nut.
Press the elbow onto the backplate,
make sure that the clips on the
elbow engage with the backplate.
To prevent the backplate from
turning while tightening the nut, fit
the retaining ring over the backplate
nut making sure the slots engage
with the screws on the backplate,
hold the retaining ring with a wrench
while tightening the backplate nut.
Remove the retaining ring after use.
Slide the retaining ring over the
elbow and engage with the elbow
clips. Note! The retaining ring
must be engaged correctly to lock
the elbow to the backplate, rotate
the retaining ring to the postition
illustrated.
Press the shroud over the elbow,
make sure that it engages with the
lugs on the backplate.
Place first washer in end of hose,
then attach to elbow. Do not fit
showerhead until after pipework
has been fully flushed through. See
section "Commissioning".
Copper
Pipe
33
Backplate
2 x Screws
Copper
Backplate
Pipe
Nut
Olive
Retaining
Ring
Backplate
Foam Seal
Elbow
Retaining Ring shown
correctly engaged with
Elbow
1
2