Mira Vision Dual Installation Manual page 35

Fit the olive and compression nipple
over the outlet pipe and tighten the
compression nipple.
Fit the concealing shroud onto the
shower arm.
Fit the compression nut and olive
onto the shower arm.
Fit the shower arm into the
compression nipple and tighten the
compression nut.
Hand tighten the concealing shroud
onto the backplate.
Do not fit deluge head until
after pipework has been fully
flushed through. Refer to section
"Commissioning" in the Dual
Outlet Installation Guide.
Screw the deluge head onto the
shower arm by hand.
Note! Use a suitably sized wrench
to fully tighten (approximately 1/4
turn).
Caution! The shower arm is not
designed to take weight, therefore
care needs to be taken when
installing the deluge head.
Olive
Concealing
Shroud
Flow Regulator
(some models)
35
Backplate
Compression Nipple
Olive
Compression
Nut
Shower
Arm
Shower Arm
Deluge Head