Mira Vision Dual Installation Manual page 23

Drill and plug the fixing holes.
Note! Installers may wish to use alternative cavity fixings, when installing
onto a dry lined, stud partition, shower cubicle or laminated panel wall
structures. However, these methods of fixing are beyond the scope of this
guide.
Secure the digital mixer valve in position with the fixing screws (supplied).
Caution! Risk of product damage. Make sure both hot and cold supply
pipes are flushed thoroughly prior to connection to the digital mixer
valve. Any product malfunction caused by pipework debris is not
covered under the guarantee.
Connect the hot and cold water supply pipes to the digital mixer valve as
indicated on the product lid.
Push-fit connector to the
Shower Fittings
Install the shower fittings and wireless controller (see further instructions).
Hot Inlet
Outlets
23
Wiring to
Fused Spur Box
Cold Inlet
Push-fit Isolators fitted
to both Inlets