Table of Contents
Advertisement
System Settings
Parallel Interface
This section describes the user tools in the Parallel Interface menu under Inter-
face Settings.
Default settings are shown in bold type.
❖ Parallel Timing
2
Sets the timing for the control signal of the parallel interface.
The default setting is ACK Outside.
❖ Parallel Communication Speed
Sets the communication speed for the parallel interface.
The default setting is High Speed.
❖ Selection Signal Status
Sets the level for the select signal of the parallel interface.
The default setting is High.
❖ Input Prime
Sets whether to validate or invalidate the input prime signal upon receipt.
The default setting is Inactive.
❖ Bidirectional Communication
Sets the printer's response mode to a status acquisition request when using a
parallel interface.
The default setting is On.
When set to [Off], bidirectional communication function will be disabled. Al-
so, printer driver will not be installed under Windows Auto Detect function.
❖ Signal Control
Sets procedure to error during printing.
The default setting is Job Acceptance Priority.
52
Advertisement
Table of Contents
