Genie Z-45/25 Bi-Energy Service Manual page 33

July 2004
REV A
3 Check to be sure the engine pulley and the
generator pulley are aligned within specification
using a straightedge. Refer to Section 2,
Specifications .
a
d
a engine pulley
b straightedge
c maximum pulley offset
d generator pulley
If alignment does not meet
specification, refer to Repair
Procedure 6-3, How to Install the
Engine Drive Pulley to adjust the
pulley alignment.
Part No. 106488
b
c
Genie Z-45/25 Bi-Energy and Genie Z-45/25J Bi-Energy
Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
4 Inspect the generator belts for:
· Cracking
· Glazing
· Separation
· Breaks
5 Replace both belts if any damage is found.
6 Check the generator belts for proper tension.
Refer to Section 2, Specifications .
If the belt deflection is not within
specification, see repair procedure
7-2, How to Adjust the Generator
Belts.
a
a engine pulley
b generator belts
c generator pulley
7 Check the torque of the pulley retaining nut on
the generator. Refer to Section 2,
S pecifications .
b
c
3 - 9