Loading The Material - Roland CAMM JET CJ-70 User Manual

9 Loading the Material

Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.
When using sheet material (standard-size sheets or sheet scraps), follow steps 2 and 3, and steps 5 and 6.
1
1) Pass the stopper onto the shaft to match the width of the
roll material to be used.
(The shafts (2 pieces), stoppers (2 pieces), and stopper
retaining screws (2 pieces) are included with the stand.)
When passing the shaft through the stopper,
be sure to loosen the mounting screws on
the stopper first.
2) Align the media flange with the roll sheet edges, matching the roll sheet center ID.
(The media flange is included with the stand.)
Media flange
3) Install the two shafts on the sheet hanger and place the roll material on top of the shafts.
(The brake, E Hexagon-head socket screws (middle), and hex wrench (small) are included
with the stand.)
Sheet hanger
Shaft
Brake
Hexagonal wrench
(Small)
E Hexagon-head socket
screws (Middle)
Stopper retaining screws
Shaft
Stopper
Mount the
brake here.
Sheet hanger
Media flange
Sheet hanger
Shaft
Roll material
15