Description Of Keys And Display Menus - Roland CAMM JET CJ-70 User Manual

22 Description of Keys and Display Menus

Key Top menu
CUTTER
FORCE
CUTTER
OFFSET
CUTTER
SPEED
—
—
—
—
—
—
—
—
—
HEAD
CLEANING
ALL
TEST PRINT
MAGENTA &
BLACK &
—
40
Submenus
— This sets the blade force used for cutting.
Perform a cutting test and set this to an appropriate value
for the material and blade to be used.
— This sets the amount of offset for the blade shaft and the
blade.
— This sets the speed used for cutting.
Perform a cutting test and set this to an appropriate value
for the material and blade to be used.
— This cuts a test pattern in a piece of material for adjusting
the blade force, cutting speed, and blade compensation.
— When in the "READY" mode, these move the material
and the cutting carriage.
When a menu is displayed, these move among the menu
items.
— This enters the menu mode.
The and
the moves to a submenu, and the
moves to the previous screen.
— This is used to accept, execute, or save the item shown on
the display.
— This makes the present tool position the new origin point.
This point is used as a reference for the align point.
Any previously set align point is canceled.
— This sets the align point for canceling out any
misalignment (tilting) of the material.
The angle of the material, referenced from the base point,
is stored in memory. Any angle of 5° or less may be set.
This setting is valid only when cutting.
— This forces the tool to move up or down.
— This detects the size of the material and enters the READY
mode, where printing or cutting are possible.
— In the READY mode or BUSY mode, this pauses
operation.
Pressing this key again cancels the paused state.
Pressing the SETUP key while paused causes remaining
data to be cleared and returns to the NOT READY mode.
The unit goes into the NOT READY mode if the material
is removed while paused.
This performs cleaning of the ink head.
Using the CLEANING key causes a certain amount of
head wear and also consumes a certain amount of ink, so
use of this key should be kept to a minimum.
ALL: All four heads (magenta, yellow, black, and cyan)
are cleaned.
TEST PRINT: Test printing is performed in a range of
approx. 130 mm x 15 mm (5-1/8" x 9/16").
If a problem in printing occurs, follow this by
performing cleaning for the heads.
MAGENTA & YELLOW: Only these two heads
YELLOW (magenta and yellow) are cleaned.
BLACK & CYAN: Only these two heads (black and
CYAN cyan) are cleaned.
— This switches on and off the power .
Function
keys move to the next menu,
key
Setting range Default value
20 gf to 350 gf
(in increments of 10 gf)
0.000 mm to 1.5000 mm
(in increment of
0.025 mm)
1 cm/s—85 cm/s
(in increments of 1 cm/s)
—
—
—
—
—
—
—
—
—
—
—
30 gf
0.250 mm
50 cm/s
—
—
—
—
—
—
—
—
—
—
—