Installing The Cutter - Roland CAMM JET CJ-70 User Manual

Open the doors to the ink cartridge ports and insert the ink cartridges.
Black
Yellow
Cyan
Magenta
If the cartridge is
marked with PIGMENT
it contains pigment ink,
otherwise dye ink.
When the power is turned on for the first time, or turned on after removing the ink, the system will execute ink fill.
This operation takes several minutes.

7 Installing the Cutter

Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
When cutting is performed after printing, the cap tip of the blade holder may scratch the printed surface. If this
is the case, lengthen the cutter blade extension.
1
Insert a blade into the blade holder until it snaps
into place with an audible click.
Push-pin
Blade holder
Blade
Ink cartridge ports
Be sure to install only the dedicated ink
cartridges that have been specified for the
machine.
Dye inks cannot be used on a CJ-70/60
unit for which pigment inks are specified,
and pigment inks cannot be used on a CJ-
70/60 unit for which dye inks are
specified.
When inserting the cartridge, make sure that it is
inserted into the correct slot for that color.
2
Loosen the tool securing screw on the tool carriage.
Support the tool securing screw from below and install
the blade holder. Insert the blade holder until the collar
is flush with the carriage. Tighten the tool securing
screw until the blade holder is secured in place.
Loosen
Pigment ink
specified
Dye ink
specified
Cutting carriage
Tighten
13