Setup for Printing
1 Loading the Material
Loading Roll Material
1
Open the front cover.
2
Line up with the core diameter of the loaded roll material and refit the left- and right-hand media flanges.
(1)
(3)
Fit the hole on the left side of the roll material all the way onto the left-hand media flange.
3
4
Fit the right-hand media flange all the way into the hole on the right-hand side of the roll material, and tighten the retainer screw
to secure in place.
Left-hand media flange
28
(2)
Flange retaining pin
Line up the ridges and grooves.
Roll material
Media flange
Media flange
50.8 mm
Right-hand media flange
76.2 mm
(3 in.)
(2 in.)
(4)