Loading/Removing The Material - Roland Color CAMM PC-50 User Manual

5 Basic Operation

5-5 Loading/Removing the Material

Loading the Material
Material with a width (horizontal dimension) of 279.4 mm (11") to 482.6 mm (19") can be loaded.
Any length (vertical dimension) of 110 mm (4-3/8") or more is acceptable.
• The tool carriage moves when the SETUP key is pressed. Take care to ensure that your hands or other objects do not
get caught in the moving parts.
• A soiled material may impair printing accuracy. If dirt or oils from the hand are transferred to the material when it is
loaded, use a cloth moistened with alcohol to wipe the material clean before printing.
NOTICE
Never move the tool carriage by hand. Damage and poor performance may result.
1
1) Raise the sheet loading lever.
5) Move the pinch roller to the
left-hand edge of the
material.
* Before attempting to move the pinch roller,
be sure to raise the sheet loading lever.
When using roll material
3) Pass the end of the material
between the pinch rollers and
the grid rollers so that it extends
from the front of the unit.
2
Lower the sheet loading levers to secure the material in place.
10
3) Pass the material between
the pinch rollers and the
grit roller.
Inner side of
the material
1) Load roll material on the sheet base included
Rear
Front
Sheet loading lever
2) Move the right-hand pinch roller
with the PC-50.
Roll material
Pull out the amount of roll
material to be used.
Roller base
2) Gently press the roll material against the rear surface
of the unit as shown in the figure.
3
The SETUP LED
lights up
until it makes contact.
Guide lines
4) Right side of the material to
be placed at front and rear
guide lines.
Press the SETUP key.