About The Printing/Cutting Area - Roland CAMM JET CJ-70 User Manual

20 About the Printing/Cutting Area

The printing/cutting area along the horizontal plane (the direction in which the carriage moves) is determined by the position of the pinch
rollers. The workable area spans the length between the two rollers, minus a margin of about 1 mm (about 0.04") on both sides.
If "PIECE" has been selected and material length (the distance in the X direction as shown in the figure) is 1,885 mm (74-3/16") (1,257
mm (49-7/16") x 1.5) on the CJ-70 or 1,537 mm (60-1/2") (1,025 mm (40-5/16") x 1.5) on the CJ-60, the area is the same as when
"EDGE" has been chosen.
If "ROLL" or "EDGE" has been selected, the material length (the distance in the X direction as shown in the figure) is set to 24,998 mm
(984-1/8").
10 mm
(3/8")
Pinch roller (left)
Approx. 15 mm
(about 9/16")
20 mm (13/16")
(If the material configuration is "EDGE" or "PIECE.")
36
Max.:
[CJ-70] 1257 mm (49-7/16)
[CJ-60] 1025 mm (40-5/16")
Max.: 24998 mm
(984-1/8")
Approx. 1 mm
(about 0.04")
Material
Printing/cutting area
Approx. 1 mm
(about 0.04")
* The arrows in the figure indicating the X and Y directions indicate
respectively the positive directions of the X axis and Y axis.
10 mm
Pinch roller (right)
(3/8")
Approx. 15 mm
(about 9/16")
20 mm (13/16")
(If the material configuration
is "EDGE" or "PIECE.")
Printing/cutting
coordinates origin (0, 0)