Loading The Material; Loading Roll Material - Roland FJ-50 User Manual

2-4 Loading the Material

Roll material must be placed at a
predetermined shaft position.
Failure to do so may
result in falling of the
roll, leading to injury.

Loading Roll Material

1
Secure the retainer on the left-hand side in place at the
location shown in the figure.
Tighten the screw to secure in place.
* When using roll material, the retainer on the left-
hand side should always be used secured in
place at the location shown in the figure.
2
Line up with the core diameter of the loaded roll material and refit
the left- and right-hand media flanges.
Flange retaining pin
(1)
(3)
Acceptable material widths
FJ-50
FJ-40
Rear
Media flange
(2)
Line up the ridges and grooves.
2 Basic Operation
210 mm to 1350 mm (8-5/16" to 53-1/8")
210 mm to 1125 mm (8-5/16" to 44-1/4")
Left-hand retainer
100 mm (3-15/16")
Media flange
50.8 mm
(2")
(4)
76.2 mm
(3")
19