Interface Specifications - Roland CAMM JET CJ-70 User Manual

(*) The following conditions must be satisfied:
- Material type: 3M Scotchcal Mastercut Film, ARLON Series 2100
- Special stand (a roll material must be set at the rear and on the inner sheet hanger)
- Side margins: 25 mm (1") or more for both the left and right margins
- Front margin: 25 mm (1") or more
- Use of the display menu's "PREFEED" function to perform feed of the material length plus 0.2 m (7-7/8") or more and set the
material correctly
- Cutting of the following data one time
Side margins: 25 mm (1") or more
Front margin: 25 mm (1") or more
Pinch roller (left)
Pinch roller (right)

Interface Specifications

[Parallel]
Standard
Input signals
Output signals
Level of input output signals
Transmission method
[Serial]
Standard
Transmission method
Transmission speed
Parity check
Data bits
Stop bits
Cutter
protector
Origin
Side margins:
Feed length
25 mm (1")
Sheets with a width exceeding 610 mm (24"): 4,000 mm (157-7/16")
or more
Sheets with a width of 610 mm (24") or less : 8,000 mm (315-15/16")
In compliance with the specifications of Centronics
STROBE (1 BIT), DATA (8 BITS)
BUSY (1 BIT), ACK (1 BIT)
TTL level
Asynchronous
RS-232C specifications
Asynchronous, duplex data transmission
4800, 9600, or 19200 (selected using operation panel)
Odd, Even, or None (selected using operation panel)
8 bits
1 bit
(1) The letters are cut in order starting with "R"
(2) After the last letter ("P") has been cut, the machine returns to the origin
point and the outer border is cut
Cut length
Fills the
hard clip
47