Loading Material (Using The Adhesive Sheet) - Roland Metaza MPX-80 User Manual

3-4 Loading Material (Using the Adhesive Sheet)

Loading Material Using the Adhesive Sheet
Procedure
–
Head cap
—
knob
˜
Mounting the Adhesive Sheet
➢ Place it straight, aligned with the scale marks on the table.
➢ Place inside the table frame.
➢ Be careful not to allow any air bubbles to form between the adhesive
sheet and the table.
How to Place Material
Place the material at the center of the scale on the table.
If you're performing printing with the head cap attached, this completes loading of the material.
If you're performing printing with no head cap attached, then go on to the following steps.
Head
Head cap
Material Adhesive sheet
Attach a head cap.
Fit the head cap into place on the tip of the
head. The head cap is attached correctly when
its tab clicks into place in the hole in the head.
Head
P. 27, "Head Caps"
Loosen the knob.
Affix the adhesive sheet to the table,
then mount the material on the sheet.
Press down lightly on the material to secure
it in place.
Adhesive
sheet
Center line
Chapter 3 Performing Printing
Table
Center
line
Center of
the material
Material
31