Panasonic FP2 -C1A Manual page 40

Initial Settings
5.1 Analog Input Initial Settings
5.1.2 Analog Input Range Setting
Specifies the input range code when setting input ranges for each input channel.
(Set the range setting switch to "Enable setting by software" and conversion will not be
executed for that input channel if there is not input range code specification.)
Program example:
When ch0: ±10V, ch1: 1 to 5V, ch2: thermocouple K, and ch3: R.T.D. Pt100
R9013
F151 WRT , K0 , DT 0 , K2 , K18
Initial setting
When the analog input
unit is installed at slot 0
Shared memory address 18 is head address
5.1.3 Average Processing Times Setting
Specifies the average times for each input channel.
If there is no specification for the average times, then that input channel will perform
normal sampling.
Also:
K0 (0 times) is specified: No average processing, and normal sampling processing.
K1 (1 time) is specified: No average processing, and normal sampling processing.
K2 (2 times) is specified: No average processing, and normal sampling processing.
Other than K0 to K64 (0 to 64 times) is specified: average processing is performed with
K64 as the specified setting.
Program example:
When ch0: No average processing, ch1: 3 times, ch2: 10 times, ch3: 20 times
R9013
F151 WRT , K0 , DT0 , K4 , K22
Initial setting
When the analog input
unit is installed at slot 0
Shared memory address 22 is head address
5 - 4
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DT0 = H0701
DT1 = H120E
DT0 = K0
DT1 = K3
DT2 = K10
DT3 = K20
FP2 Analog Unit