Analog Input Initial Settings - Panasonic FP2 -C1A Manual

FP2 Analog Unit
5.1

Analog Input Initial Settings

Performs the initial settings for each channel of the analog input. The initial settings are
set by the sequence program at the first scan at the start of operation. (The initial settings
for the analog unit are enabled only for one time after operation start.)
The items for the initial settings are given below.
No execution of analog input conversion processing setting
D
(when you want to eliminate conversion processing time for unused
input channels)
Analog input range setting (when you want to set the input range
D
individually for each channel)
Average processing times setting (when you want to perform
D
average processing for the conversion data)
Analog input offset change setting (when you want to adjust the
D
offset for the conversion data)
5.1.1 No Execution of Analog Input Conversion Processing Setting
Specifies the input channels that will not execute conversion processing.
(The default setting is for all channels to execute conversion processing.)
Program example:
Ch0 and ch1 will execute conversion processing, and ch2 and ch3 will not
R9013
F151 WRT , K0 , DT 0 , K1 , K16
Initial setting
When the analog input
unit is installed at slot 0
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
DT0 = H0011
Shared memory address 16
Initial Settings
5.1 Analog Input Initial Settings
5 - 3