Panasonic FP2 -C1A Manual page 107

FP2 Analog Unit
Item
Digital output g p Averaging
processing i
Offset setting
Broken wire sensing
Input range change method p g g
Conversion execution processing channels
setting
Permission R.T.D input
resistance of input
wire
Input conversion p Input range
d t data setup time t ti
Voltage input range
(After FP2 system
(all channels together)
power has been power has been
turned on) Current input range
(all channels together)
Thermocouple input
range (all channels
together)
R.T.D input range
(all channels together)
Notes
1) Only when the DIP switch setting is setting the range for all the
channels together. For information regarding when the shared
memory is used to set the ranges for each channel, refer to
"section 6.2 Analog I/O Conversion Cycle Time."
2) The full scale (F.S.) for each of analog input voltage 1 to 5V,
current 4 to 20mA and T range of thermocouple is ±10V,
± 20mA and -200 to 1,000
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
14.1 Table of Performance Specifications
Specifications
3 to 64 times/each channels
K - 2047 to K+2047/ each channels
Only thermocouple range or R.T.D input range/each channels
All channels: By dip switch setting
Each channels: By shared memory setting
Each channels: By shared memory setting
Under 30Ω (each side)
FP2 - C1A
460ms
460ms
910ms
3350ms
C/-328 to +1,832
_
Specifications
FP2 - AD8
430ms
430ms
1330ms
6490ms
F respectively.
_
14 - 5