Henny Penny LVG-202 Service Manual page 8

Problem
With power switch in ON position,
the fryer is completely inoperative
(NO POWER)
Oil will not heat but lights
are on
No Heat error "E-22"
Aug. 2012
Cause
POWER SECTION
• Open circuit
HEATING OF SHORTENING SECTION
• Blown fuse or tripped
• Faulty power switch.
• Faulty cord and plug
• Faulty drain switch
• Faulty PC Board
• High limit control switch
"E-10"
tripped
1-3
Model LVG-202, 203, 204
Correction
• Check to see that unit is plugged in
• Check the breaker or fuse at supply
box
• Check voltage at wall receptacle
• Check MAIN POWERswitch; re-
place if defective
• Check cord and plug
• Reset transformer circuit breaker
• Reset breaker or replace fuse circuit
breaker at supply box or control panel
• Check power switch
• Check cord and plug
• Check power at receptacle
• Check drain switch
• Check control panel per maintenance
section and replace as needed
• Allow fryer to cool for 15-20
minutes; reset high limit by
pressing down & releasing raised
side of the switch for the vat that is
not operating; a single reset switch
is found behind the door of each
well; if high limit does not reset,
high limit must be replaced