Henny Penny LVG-202 Service Manual page 10

Problem
Vat is under-filled
Bubbles in oil during
entire filtering process
Filter motor runs but
pumps oil slowly
Filter motor will not run
July 2013
Cause
OIL LEVEL SECTION (Continued)
• Locations with RTI, the 3-way
valve is stuck open
• Filter pan needs cleaned
• JIB is low or empty
• JIB oil line is clogged or
collapsed
• Quick Disconnect O-ring may
be worn or missing
• Filter pan needs cleaned
• Filter pan not completely
engaged
• Filter pan clogged
Damaged o-ring on filter line
•
tube on fryer
FILTER MOTOR SECTION
• Filter line connections loose
• Drain pan o-rings damaged or
missing
• Filter paper or pad clogged
• Thermal reset button on the rear
of the pump motor is tripped
To prevent burns caused by splash-
ing shortening, turn the unit's
POWER switch to the OFF position
before resetting the filter pump mo-
tor's manual reset
protection device.
1-5
Model LVG-202, 203, 204
Correction
• The RTI system can be
disconnected until RTI repairs the
valve
Clean filter pan and change pad
•
• Fill the JIB
• Check JIB line
• Check JIB Disconnect O-ring
for wear or cracking. Replace if
missing or torn
Clean filter pan and change pad
•
Make sure filter pan return line
•
is pushed completely into the
receiver on the fryer
• Clean pan and change pad
• Change o-ring
Tighten all filter line connections
•
• Install new o-rings
Change filter paper or pad
•
• Allow time for the motor to cool.
Open front door and using at
least a 12 in. (305 mm) Phillip's head
screwdriver, press on the thermal reset
button by prying hard between the
button and the door frame until button
clicks