Henny Penny LVG-202 Service Manual page 19

3-1. MODIFYING PRODUCT
SETTINGS (CONTINUED)
Aug. 2012
8. Press and release▼ button and "TEMP" shows in the dis-
play, along with the preset temperature on the right side of
the display.
Press the product buttons
to change the temperature. The temperature range is 190°F
(88°C) to 380°F (193°C).
Cook ID Change
9. Press ▼ button until "COOK ID" shows in the display
along with the product ID. For example, NUG would be
the ID for nuggets. Use the product buttons to change the
ID, following the same procedure as Step 6 above.
Alarms (Duty 1 & 2)
10. Press ▼ button until "DUTY 1" shows in left display,
and an alarm time in the right display. Press the product
buttons
Ex., If a Cook Cycle was set at 3 minutes, and an alarm
was to go off after 30 seconds into the Cook Cycle, "0:30"
would be set in the display at this time. When the timer
counts down to 2:30 the alarm sounds.
After alarm time is set, press ▼ button and "DUTY 2"
shows in display, and a second alarm can be programmed.
Quality Timer
11. Press ▼ button until QUAL TMR shows in display along
with preset holding time. Press product buttons to adjust
AIF Disable
12. Press ▼ button until "AIF DISABLE" shows in display
along with "YES" or "NO". Using ◄ and ► buttons
change the display to "YES" if that product is to not be
included in the automatic intermittent filtration operation,
or "NO" if it is to be included.
Assign Button
13. Press ▼ button until "ASSIGN BTN" shows in the dis-
play, along with the product (ex: NUGGETS). If this prod-
uct already has a product button assigned to it, that LED
will be lit. To assign other product buttons to that product,
press and hold the product button for 3 seconds and that
LED stays lit. To remove a product from a button, press
and hold the product button with a lit LED and the LED
goes out.
3-2
Model LVG-202, 203, 204
to set an alarm.
hold time (2 hrs., 59 min. max.).