Henny Penny LVG-202 Service Manual page 14

1-4. ERROR CODES (CONTINUED)
AIF PC board not communicating
with control PC board
"E-60"
"E-62A" Communication Error
"E-62B" Wrong Calibration Error
Drain valve jumper wire missing or
"E-70-C"
disconnected
Selector Valve not detected
"E-82A"
Selector Valve failed
"E-82B"
Selector Valve failed
"E-82C"
Selector Valve failed
"E-82-D"
"E-83" Pressure Trasducer senses too high
pressure in AIF system
"PRES-
SURE "
"TOO
HIGH"
"E-83-A" Pressure too high
"E-83-B" Pressure too high
"E-83-C" Pressure too high
"E-83-D" Pressure too high
"E-83-E" Pressure too high
RTI "JIB FILL" switch ON when
"E-83-J"
pressure too high
RTI "DISPOSE" switch ON when
"E-83-R"
pressure too high
"E-83-Z" Unknown source
"E-93-A" 24VDC tripped
May 2014
Turn switch to OFF, then back to ON; if "E-60"
persists, check 1.5 amp fuse on AIF PC board on
International units only; check connector between
the PC boards; replace AIF PC board or control PC
board if necessary
• Loose connection. Refer to Service Manual.
• Replace control board.
• Replace sensor.
• Enable OQM on control board 1.
• Replace OQM Sensor. Refer to Service Manu-
al.
Have the jumper wire checked on the PC board at
drain switch interlock position
Have wiring checked between Selector Valve and
AIF board
Have the "Home" switch on Selector Valve
checked
Have wiring checked between the "Home" &
"Position" encoder and the Selector Valve; Have
Selector Valve Motor checked; Have drive chain
checked
Have the "Home" switch and the "Position" switch
on Selector Valve checked
Check AIF system or the RTI quick-disconnect;
See details below;
Check AIF system in Vat #1
Check AIF system in Vat #2
Check AIF system in Vat #3
Check AIF system in Vat #4
Check AIF system in Vat #5
Check JIB fill valves
Check RTI quick-disconnect behind fryer; RTI
phone no. if needed: 888-796-4997
Check RTI system & JIB fill valve
Have drain actuator checked
1-9
Model LVG-202, 203, 204