Using The Buzzer - Omron NT20S Operation Manual

Various System Settings
3-8-2

Using the Buzzer

Setting the Buzzer
To Stop the Buzzer Sound
Reference: If a buzzer stop attribute has been set to a touch switch created on the screen in
92
To set and quit the menu, press the [WRT & EXIT] touch switch. To quit without
setting, press [Quit].
S ON: The key press sound will be given for 0.2 second when a touch switch is
pressed.
S OFF: The key press sound will not be given when a touch key is pressed.
The NT20S can set a buzzer to indicate the occurrence of an emergency or an
NT20S error.
Except when the buzzer has been set so as not to sound at all, the buzzer will
sound when an error occurs. To set the buzzer to sound in other cases, the follow-
ing two procedures can be used.
S Controlled by the Host
It is possible to control the NT20S from the Host to sound the buzzer during the
operation.
Refer to Section 5-4 NT20S Status Control (page 191).
S Set the buzzer as a screen data attribute by using the support tool.
When creating the screen data by using the support tool, set the buzzer as a
screen attribute so that the buzzer will sound. When the screen in which this at-
tribute has been set is displayed, the NT20S will give the buzzer sound.
If the control by the Host and the display of the screen in which the buzzer attribute
has been set are executed simultaneously, the priority is given to the control by the
Host. Refer to the NT-series Support Tool Operation Manual (V028-E1-j).
The buzzer sound can be stopped by the following operation.
S Control by the Host
S Switch the screen to a screen which does not have a buzzer attribute.
S Press the touch switch to which the buzzer stop attribute has been set.
which the buzzer attribute has been set, such touch switch can be used to stop the
buzzer sound. For details on setting buzzer attributes for touch switches, see "Al-
location of System Key Functions" (page 139).
Section 3-8