Checking The Nt20S Dip Switch Settings - Omron NT20S Operation Manual

System Maintenance
3-9-3

Checking the NT20S DIP Switch Settings

Display the NT20S DIP switch settings by using the menu operation from the Sys-
tem Menu as mentioned below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
Init. Memory
Memory Switch
[ DIP-SWITCH STATUS ]
1. Forced Init.
2. Message Mode
3. Mode Change
4. Reserved
EXIT
S The NT20S DIP switch statuses are displayed.
S Pressing the EXIT touch switch clears the DIP switch status display from the
screen and causes the NT20S to enter the RUN mode.
Note: If the DIP switch settings have been changed when the NT20S is powered, reset
the power to the NT20S. The changes with the DIP switches become effective only
after the power supply is reset.
DIP-SW Status
No
English
Enable
OFF
1 2 3 4
[SW2]
Select "Maintenance Mode".
Select "DIP-SW Status".
ON
OFF
Section 3-9
109