Key To Programs; Use Of Programs - Omron NT20S Operation Manual

Key to Programs

6-7

Key to Programs

6-7-1

Use of Programs

Send command column
Interrupt display when
command received
222
The following programs include all the commands that can be used with the
NT20S.
The sample program appears as follows on the screen.
Menu bar Sub-menu
Use the program as shown below.
[ESC]
[ESC]
[ESC]
1. This sample program is written in N88BASIC (86) (NEC) for a PC-9801
computer. Modify this program for use with any other computer lan-
guage or computer such as an IBM PC/AT or compatible.
2. The interval between parameter input and command transmission is a
hold interval for interrupt processing of the received command. If an in-
terrupt is permitted between the interval of parameter input and a com-
mand is received, all subsequent receive interrupts are displaced. If this
occurs, send an enquiry command to read all the accumulated receive
data.
3. When a parameter is input, no check is made that the parameter is in the
permitted range. Make sure that parameters are input within the per-
mitted range.
Parameter input column
Execute program
Select type of send
command
Select send command
Input parameter
Confirm send command
Execute transfer
command
End program
Section 6-7
Run confirm column
Receive command
display column
Main Menu
Sub-menu
Input parameter column
Send command column,
confirm execution
Up, Down, Left, Right keys: select item
[ENT]: confirm
[Esc]: stop