Initialization By Using The Dip Switch (Forced Initialization) - Omron NT20S Operation Manual

Initializing Memory
3-4-2

Initialization by Using the DIP Switch (Forced Initialization)

Operation 1. Set DIP SW2-1 on the NT20S to ON and turn the power ON or reset the
Reference: S Selecting "No" will cancel the memory initialization. In either case, when chang-
74
Note: Be sure to turn the power OFF before setting the NT20S DIP switch.
Set the DIP switch as follows to initialize the screen data memory.
NT20S.
Initialize Screen Memory?
Yes
No
Initialized the
Turn OFF the DIP Switch 2-1
and push the Reset Switch,
then return to RUN mode.
2. Turn the NT20S power to OFF.
3. Set NT20S DIP SW2-1 to OFF and turn the power ON.
ing the system settings or registering screen data, display the system menu after
setting DIP switch SW2-1 to the OFF position while the NT20S power is OFF,
then switching the power back ON.
S The NT20S DIP SW2-1 is used to set "Screen data forced initialize Yes/No". Set-
ting this to Yes selects "effective", and No "ineffective".
Screen Data Memory.
Section 3-4
Select "Yes".
The screen data memory is ini-
tialized. During the initialization,
the "Initializing" message will be
displayed.