Wheels And Tires; General Information; Tire Sealant And Inflator Kit - Ford Mustang 2017 Owner's Manual

GENERAL INFORMATION

A decal with tire pressure data is located
in the driver's door opening.
Check and set the tire pressure at the
ambient temperature in which you are
intending to drive your vehicle and when
the tires are cold.
Note: Check your tire pressures regularly to
optimize fuel economy.
Note: Use only approved wheel and tire
sizes. Using other sizes could damage your
vehicle and will make the National Type
Approval invalid.
Note: If you change the diameter of the tires
from that fitted at the factory, the
speedometer may not display the correct
speed. Take your vehicle to an authorized
dealer to have the engine management
system reprogrammed.
TIRE SEALANT AND INFLATOR
KIT
(If Equipped)
Note: The temporary mobility kit contains
enough sealant compound in the canister
for one tire repair only. See an authorized
Ford dealer for replacement sealant
canisters.
The kit is located under the load floor in
the trunk. The kit consists of an air
compressor to re-inflate the tire and a
canister of sealing compound that will
effectively seal most punctures caused by
nails or similar objects. This kit provides a
temporary tire repair, allowing you to drive
your vehicle up to 200 km (120 mi) at a
maximum speed of 80 km/h (50 mph) to
reach a tire service location.
Mustang (CZG, CZY) Vehicles Built From: 02-05-2016, HR3J 19A321 AKA enGBR, First Printing

Wheels and Tires

E175977
178
A Air compressor (inside).
B Selector switch.
C On and off button.
D Air pressure gauge.
E Sealant bottle and canister.
F Dual purpose hose: air and
repair.
G Tire valve connector.
H Accessory power plug.
I Casing/housing.
J Bike/raft/sports ball adapters.