Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

MPLS Multilink PPP Support
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Step 6 show mpls forwarding-table
Displays contents of the Multiprotocol Label Switching (MPLS) Label Forwarding Information Base (LFIB). Look for
information on multilink interfaces associated with a point2point next hop.
Example:
Device# show mpls forwarding-table
Local Outgoing
tag tag or VC
16 Untagged
17 Pop tag
18 Untagged
19 Untagged
20 Untagged
21 Aggregate
22 Untagged
Use the show ip bgp vpnv4 command to display VPN address information from the Border Gateway Protocol (BGP)
table.
Example:
Device# show ip bgp vpnv4 all summary
BGP router identifier 10.0.0.1, local AS number 100
BGP table version is 21, main routing table version 21
10 network entries using 1210 bytes of memory
10 path entries using 640 bytes of memory
2 BGP path attribute entries using 120 bytes of memory
1 BGP extended community entries using 24 bytes of memory
0 BGP route-map cache entries using 0 bytes of memory
0 BGP filter-list cache entries using 0 bytes of memory
BGP using 1994 total bytes of memory
BGP activity 10/0 prefixes, 10/0 paths, scan interval 5 secs
10.0.0.3 4 100 MsgRc52 MsgSe52
Step 7
exit
Returns to user EXEC mode.
Example:
Device# exit
Device>
Prefix Bytes tag
or Tunnel Id switched
10.30.0.1/32 0
10.0.0.3/32 0
10.0.0.9/32[V] 0
10.0.0.11/32[V] 6890
10.32.0.0/8[V] 530
10.34.0.0/8[V] 0
10.34.0.1/32[V] 0
TblV21 0

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

Verifying the Multilink PPP Configuration
Outgoing Next Hop
interface
Mu6 point2point
Mu6 point2point
Mu10 point2point
Mu10 point2point
Mu10 point2point
Mu10 point2point
0 00:46:35 State/P5xRcd
59