Cisco ASR 900 Series Manual page 153

Flex LSP Overview
Backup:
Interface: 0 protected, 0 rerouted
Path Protection Summary:
1 configured, 1 Up, 0 ready
0 link-diverse, 0 node-diverse, 0 node-link-diverse, 0 user defined
Bidirectional Tunnel Summary:
Tunnel Head: 1 total, 1 connected, 1 associated, 1 co-routed<------ To check how many
tunnels are connected
Tunnel Tail: 1 total, 1 connected, 1 associated, 1 co-routed
LSPs Head:
LSPs Mid:
LSPs Tail:
GMPLS UNI Summary:
Heads:
Tails:
GMPLS NNI Summary:
Heads:
Mids :
Tails:
RP/0/RSP0/CPU0:NCS4K-R1#
To verify the co-routed LSP, use the Show mpls traffic-eng tunnel bidirectional co-routed command.
Router#Show mpls traffic-eng tunnel bidirectional co-routed
Name: tunnel-te2
Status:
Admin:
path option 1,
Bandwidth Requested: 80000 kbps
Config Parameters:
Association Type: Single Sided Bidirectional LSPs, Co-routed: Yes
Association ID: 100, Source: 9.9.9.9[, Global ID: 9]
Reverse Bandwidth: 2 kbps CT0, Standby: 2 kbps CT0
BFD Fast Detection: Enabled
BFD Parameters: Min-interval 10000 ms, Multiplier 3 (default)
BFD Bringup Timeout: Interval 60 seconds (default)
BFD Initial Dampening: 16000 ms (default)
BFD Maximum Dampening: 600000 ms (default)
BFD Secondary Dampening: 20000 ms (default)
Periodic LSP Ping: Interval 120 seconds (default)
BFD Encap Mode: IP (default) | GAL
Soft Preemption: Enabled, Current Status: Preemption not pending
To verify the RSVP session details, use the show rsvp session detail command.
Router# show rsvp session detail
RP/0/0/CPU0:rtrA#show rsvp session detail dst-port 2
SESSION: IPv4-LSP Addr: 192.168.0.3, TunID: 2, ExtID: 192.168.0.1
0 tunnels, 0 assigned
1 established, 0 proceeding, 1 associated, 0 standby
0 established, 0 proceeding, 0 associated, 0 standby
1 established, 0 proceeding, 1 associated, 0 standby
0 up, 0 down
0 up, 0 down
0 up, 0 down
0 up, 0 down
0 up, 0 down
Destination: 192.168.0.3
up Oper: up Path:
type dynamic (Basis for Setup, path weight 3 (reverse 3))
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Verifying the Co-routed Flex LSP Configuration
valid Signalling: connected
CT0
145