How To Configure Structure-Agnostic Tdm Over Packet - Cisco ASR 900 Series Manual

Circuit Emulation Service over UDP

How to Configure Structure-Agnostic TDM over Packet

Perform the following task to configure Structure-Agnostic TDM over Packet (SAToP):
SUMMARY STEPS
1. enable
2. configure terminal
3. interface loopback interface-number
4. ip address ip-address mask [secondary]
5. cemoudp reserve bay bay-number
6. pseudowire-class pseudowire-class-name
7. encapsulation udp
8. ip local interface loopback
9. ip tos value number
10. ip ttl
11. exit
12. controller {e1 | t1} slot / subslot / port
13. clock source {internal | line | loop}
14. framing number {esf | sf | crc4 | no-crc4 | unframed}
15. cem-group number unframed
16. exit
17. interface cem
18. cem
19. xconnect peer-router-id vcid pw-class name
20. udp port local local-udp-port remote remote-udp-port
21. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
interface-number
number
slot / subslot / port
group-number
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Structure-Agnostic TDM over Packet over UDP
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
133