Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

MPLS Transport Profile
Command or Action
Step 4
encapsulation mpls
Example:
Device(config-pw-class)# encapsulation mpls
Step 5 control-word
Example:
Device(config-pw-class)# control-word
Step 6
mpls label protocol [ldp | none]
Example:
Device(config-pw-class)# protocol none
Step 7 exit
Example:
Device(config-pw-class)# exit
Step 8 pseudowire-class class-name
Example:
Device(config)# pseudowire-class mpls-tp-class1
Step 9 encapsulation mpls
Example:
Device(config-pw-class)# encapsulation mpls
Step 10
exit
Example:
Device(config-pw-class)# exit
Step 11 l2 vfi name point-to-point
Example:
Device(config)# l2 vfi atom point-to-point
Step 12 neighbor ip-address vc-id {encapsulation mpls | pw-class
pw-class-name}
Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

Purpose
Specifies the encapsulation type.
Enables the use of the control word.
Specifies the type of protocol.
Exits pseudowire class configuration mode and returns
to global configuration mode.
Creates a pseudowire class and enters pseudowire class
configuration mode.
Specifies the encapsulation type.
Exits pseudowire class configuration mode and returns
to global configuration mode.
Creates a point-to-point Layer 2 virtual forwarding
interface (VFI) and enters VFI configuration mode.
Sets up an emulated VC and enters VFI neighbor
configuration mode.
39