Configuring The Pseudowire - Cisco ASR 900 Series Manual

MPLS Transport Profile
Command or Action
Step 9
end
Example:
Device(config-pw-class)# end

Configuring the Pseudowire

SUMMARY STEPS
1. enable
2. configure terminal
3. interfaceinterface-id
4. service instance number ethernet [name]
5. mpls label local-pseudowire-label remote-pseudowire-label
6. mpls control-word
7. backup delay {enable-delay-period | never} {disable-delay-period | never}
8. backup peer peer-router-ip-addr vcid [pw-class pw-class-name] [priority value]
9. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 interfaceinterface-id
Example:
Router(config)# interface gigabitethernet
0/0/4
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the port on which to create the pseudowire and enters
interface configuration mode. Valid interfaces are physical Ethernet
ports.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Configuring the Pseudowire
Purpose
Exits pseudowire class configuration mode and
returns to privileged EXEC mode.
25