Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP
Command or Action
Example:
Device(config-vfi)# neighbor 10.111.111.111 123
pw-class atom
Step 13 neighbor ip-address vc-id {encapsulation mpls | pw-class
pw-class-name}
Example:
Device(config-vfi-neighbor)# neighbor
10.111.111.111 123 pw-class atom
Step 14 mpls label local-pseudowire-label remote-pseudowire-label
Example:
Device(config-vfi-neighbor)# mpls label 10000 25000
Step 15
mpls control-word
Example:
Device(config-vfi-neighbor)# mpls control-word
Step 16 local interface pseudowire-type
Example:
Device(config-vfi-neighbor)# local interface 4
Step 17 Do one of the following:
• tlv [type-name] type-value length [dec | hexstr | str]
value
• tlv template template-name
Example:
Device(config-vfi-neighbor)# tlv statictemp 2 4
hexstr 1
Step 18 end
Example:
Device(config-vfi-neighbor)# end

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

40
Purpose
Note: Only two neighbor commands are
Note
allowed for each l2 vfi point-to-point
command.
Sets up an emulated VC.
Note Only two neighbor commands are allowed
for each l2 vfi point-to-point command.
Configures the static pseudowire connection by
defining local and remote circuit labels.
Specifies the control word.
Specifies the pseudowire type.
Specifies the TLV parameters or invokes a previously
configured TLV template.
Ends the session.
MPLS Transport Profile