Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

Configuring Static-to-Dynamic Multisegment Pseudowires for MPLS-TP
SUMMARY STEPS
1. enable
2. configure terminal
3. pseudowire-class class-name
4. encapsulation mpls
5. control-word
6. mpls label protocol [ldp | none]
7. exit
8. pseudowire-class class-name
9. encapsulation mpls
10. exit
11. l2 vfi name point-to-point
12. neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
13. neighbor ip-address vc-id {encapsulation mpls | pw-class pw-class-name}
14. mpls label local-pseudowire-label remote-pseudowire-label
15. mpls control-word
16. local interface pseudowire-type
17. Do one of the following:
18. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 pseudowire-class class-name
Example:
Device(config)# pseudowire-class mpls-tp-class1

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

38
• tlv [type-name] type-value length [dec | hexstr | str] value
• tlv template template-name
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Creates a pseudowire class and enters pseudowire class
configuration mode.
MPLS Transport Profile