Verifying The Configuration - Cisco ASR 900 Series Manual

VPLS Configuration over MPLS-TP
Command or Action
Step 5 show interfaces type interface-path-id
Example:
router# show interfaces Loopback 3

Verifying the Configuration

You can use the following commands to verify your configuration:
• show mpls l2transport vc—Displays information about Any Transport over MPLS (AToM) virtual
• show mpls tp—Displays information about Multiprotocol Label Switching (MPLS) transport profile
• show bfd summary—Displays summary information for Bidirectional Forwarding Protocol (BFD).
• show xconnect—Displays information about xconnect attachment circuits and pseudowires.
You can use the following commands to debug your configuration:
• debug mpls tp all—Debug for all MPLS-TP information.
• debug mpls tp cli—Debug for MPLS-TP CLI
• debug mpls tp error—Debug for MPLS-TP errors
• debug mpls tp event—Debug for MPLS events
• debug mpls tp fault-oam—Debug for Fault-OAM
• debug mpls tp ha—Debug for High availability
• debug mpls tp init—Debug for MPLS-TP initialization
• debug mpls tp link-management—Debug for link management
• debug mpls tp link-num—Debug for link number database
• debug mpls tp lsp-db—Debug for LSP database
• debug mpls tp lsp-ep—Debug for endpoint LSP configuration and operation
• debug mpls tp lsp-mp—Debug for midpoint LSP configuration and operation
• debug mpls tp mem—Debug for memory allocation and usage
• debug mpls tp tun-db—Debug for the tunnel database
• debug mpls tp tunnel—Debug for tunnel configuration and operation
circuits (VCs) and static pseudowires that have been enabled to route Layer 2 packets on the router.
(TP) tunnels.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Purpose
Use the commit command to save the configuration changes to
Note
the running configuration file and remain within the configuration
session.
(Optional) Displays the configuration of the loopback interface.
Verifying the Configuration
121