Verifying That The Lsp Is Set Up Correctly; Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

ICMP ping and trace Commands and Troubleshooting
next-address 10.131.159.226
next-address 10.131.191.230
!
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
exec-timeout 0 0
password lab
login
!
end
Device CE2 Configuration
version 12.0
!
hostname ce2
!
enable password lab
!
interface Loopback0
ip address 10.131.159.253 255.255.255.255
no ip directed-broadcast
!
interface GigabitEthernet0/0/2
ip address 10.0.0.2 255.255.255.255
no ip directed-broadcast
no keepalive
no cdp enable
!
end

Verifying That the LSP Is Set Up Correctly

A show mpls forwarding-table command shows that tunnel 1 is in the Multiprotocol Label Switching (MPLS)
forwarding table.
Device# show mpls forwarding-table 10.131.159.252
Local
tag
22
[T] 10.131.159.252/32 0
[T]
A show mpls traffic-eng tunnels tunnel 1 command entered at PE1 displays information about tunnel 1 and
verifies that it is forwarding packets with an out label of 22.
Device# show mpls traffic-eng tunnels tunnel 1
Name: PE1_t1
Status:
Admin: up
path option 1, type dynamic (Basis for Setup, path weight 20)
Config Parameters:
Bandwidth: 512
Metric Type: TE (default)
AutoRoute:
auto-bw: disabled
Active Path Option Parameters:
State: dynamic path option 1 is active
BandwidthOverride: disabled
InLabel

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

90
Outgoing Prefix
tag or VC or Tunnel Id
19
point2point
Forwarding through a TSP tunnel.
View additional tagging info with the 'detail' option
Oper: up
kbps (Global)
enabled LockDown: disabled
: -
Bytes tag Outgoing
switched interface
Tu1
(Tunnel1) Destination: 10.131.159.251
Path: valid Signalling: connected
Priority: 2 2 Affinity: 0x0/0xFFFF
Loadshare: 512
LockDown: disabled Verbatim: disabled
MPLS LSP Ping, Traceroute, and AToM VCCV
Next Hop
bw-based