Circuit Emulation Services over Packet Switched Network over UDP
How to Configure Circuit Emulation Service over UDP
Perform the following task to configure Circuit Emulation Service over UDP:
SUMMARY STEPS
1. enable
2. configure terminal
3. interface loopback interface-number
4. ip address ip-address mask [secondary]
5. cemoudp reserve bay bay-number
6. pseudowire-class pseudowire-class-name
7. encapsulation udp
8. ip local interface loopback
9. ip tos value number
10. ip ttl
11. exit
12. controller {e1 | t1} slot / subslot / port
13. clock source {internal | line | loop}
14. cem-group number timeslots number
15. exit
16. interface cem
17. cem
18. xconnect peer-router-id vcid pw-class name
19. udp port local local-udp-port remote remote-udp-port
20. exit
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
128
interface-number
number
slot / subslot / port
group-number
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Circuit Emulation Service over UDP