How To Configure Mpls Vpns Over Ip Tunnels; Configuring The Global Vrf Definition - Cisco CRS Configuration Manual

How to Configure MPLS VPNs over IP Tunnels

For more information on configuring L2TPv3, see the
module.
Figure 11: IPv4/6VPE over L2TPv3
How to Configure MPLS VPNs over IP Tunnels
The following procedures are required to configure MPLS VPN over IP:
All procedures occur on the local PE (PE1). Corresponding procedures must be configured on the remote
Note
PE (PE2).

Configuring the Global VRF Definition

Perform this task to configure the global VRF definition.
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
40
Implementing MPLS VPNs over IP Tunnels
Implementing Layer 2 Tunnel Protocol Version 3