Printing Badges - Bosch BIS 2.3 Installation Manual

BIS 2.3 - Access Engine
NOTICE!
The strict separation between saving a layout and releasing it
i
for general use enables you safely to store half-finished or
prototype layouts for later editing, without fear that they will
inadvertently be used.
5.2.4

Printing Badges

In order to print a badge please proceed as follows:
1.
2.
3.
4.
5.
NOTICE!
i
If the preview is not satisfactory please close the dialog.
All options belonging to badges, like picture import or scanning,
selecting layouts, and so on, can only be done with a running
card personalization program. Therefore it is installed as an
automatically starting tool.
Console Window
After logon a console window is displayed for a short duration
during the starting process. If the card personalization program
Bosch Sicherheitssysteme GmbH
Release Card). This process copies the layouts to the
directory
<InstallDrive>:\MgtS\AccessEngine\CP\Layouts
Open Access Engine > Personnel Data > Print Badges
Select the personnel data for which the badge should be
printed.
Select the required layout from the combo-box Layout.
If no picture is yet available for this person, but required
for the badge, then you can photograph, imnport or scan a
picture at this point. Please refer to the ACE Card
Personalization program's own online help if further
assistance is required.
Click the button Print.
– Check the correctness of the data in the preview
before printing.
Installation manual
Setting up additional workstations | en
F.01U.028.713 | V 2.3.0.1 | 2009.11
43