Appendix A - Advanced Display Module (Adm); Display Overview; Display Details - Graco PCF Instructions - Parts Manual

Appendix A - Advanced Display Module (ADM)

NOTE: In the Advanced screens on your system, if
the Advanced Display software part number shown
is 16K405 then this manual does not apply to your
system; refer to manual 3A2098 for your system.
Otherwise, the part number shown should be
16F528 or 15V769 and you should use this manual.
ADM Software Part No. 16K405
(see manual 3A2098)

ADM Software Part No. 16F528 or 15V769
(use this manual)


Display Overview

The ADM display is divided into two main functions:
Setup Mode and Run Mode.
Setup Mode Functions
The setup mode functions enable users to:
• set units, adjust values, set formats, and view
software information for each component;
• set or change information regarding the Gate-
way module;
• view information regarding the particular Gate-
way module used;
313377L
Appendix A - Advanced Display Module (ADM)
• set controls and gun commands;
• set on and off delays for guns and the regulator;
• set k-factor, pressure, and flow rate variables;
• set offsets for inlet and outlet pressures;
• set error types;
• set variables for maintenance advisories;
• and set up to 255 styles.
Run Mode Functions
The run mode functions enable users to:
• adjust the bead scale;
• change the control mode;
• change the volume to be dispensed;
• change the target pressure;
• change the number of dispense valves used;
• view a chronological list of system errors;
• view a chronological list of jobs stored/per-
formed in the system;
• and use a preventative maintenance schedule
for the supply system, displacement pump, and
air motor.

Display Details

Power Up Screen
The following screen appears when the ADM is pow-
ered up. It remains on while the ADM runs through ini-
tialization and establishes communication with other
modules in the PCF.
85