Configure Control Settings - Graco PCF Instructions - Parts Manual

System Setup

Configure Control Settings

Set the controls for the dispense source, how dispense
commands are sent, and job settings.
1. With the system in setup mode, navigate to the Fluid
Plate set of screens.
2. Press
screen (screen 1).
3. Press to access the fields to make changes.
F . 17
IG
4. Press to open the Dispense Trigger Source
drop-down list, and select Gateway, Command
Cable, or Combined. If Command Cable is selected,
users can enable the guns. Press
the selection.
5. If the dispense trigger source is set to Command
Cable, press to move to the Enable Guns
field. Press
26
to scroll to the Control Settings
to finalize
and to enable guns.
6. Press to move to the Command Value Source
field. Press to open the drop-down list, and
select Gateway, Command Cable, or Display. Press
to enter the value.
7. Press to move to the Job End Mode field.
Press to open the drop-down list, and select
Timer or Gateway. Press
8. Press to move to the Job End Delay field.
Enter the desired delay time (in seconds). Press
to enter the value.
9. Press to move to the Run Mode Bead Adjust
field. Press to open the drop-down list, and
select Enable or Disable. Press
value.
10. Press to move to the Display Control Pass-
word field. Press
and select Enable or Disable. Press
the value.
11. Press to exit edit mode.
to enter the value.
to enter the
to open the drop-down list,
to enter
313377L